| Title of Article |
Influence of Spindle Speed on Exit Burr Height in Drilling Forging Brass |
| Date of Acceptance |
28 August 2014 |
| Journal |
| Title of Journal |
Advanced Materials Research (AMR) Journal |
| Standard |
SCOPUS |
| Institute of Journal |
Trans Tech Publications, Switzerland |
| ISBN/ISSN |
|
| Volume |
|
| Issue |
1105 |
| Month |
|
| Year of Publication |
2015 |
| Page |
159-163 |
| Abstract |
In the drilling of forging materials, exit burrs are produced on the end of hole and had some
undesirable characters leading to assembly quality problem. Deburring is one of the practical
techniques used to solve this problem. However, this technique is a time consuming and causes high
operation cost. Hence this work presented an experimental study in drilling forging brass using
special tungsten carbide drilling tools. The exit burr size was evaluated at various spindle speeds and
lot size. Effect of spindle speed on exit burr height was investigated using analysis of variance
(ANOVA). The results of ANOVA indicated that the spindle speed of 415 rpm gave lowest exit burr
height and produced higher quantity and quality of products. |
| Keyword |
Burr, drilling, forging brass, spindle speed, one-way ANOVA. |
| Author |
|
| Reviewing Status |
มีผู้ประเมินอิสระ |
| Status |
ตีพิมพ์แล้ว |
| Level of Publication |
นานาชาติ |
| citation |
true |
| Part of thesis |
true |
| Attach file |
|
| Citation |
0
|
|
|
Publication
Journal Publication
ไทย