|
|
Publication
|
| Title of Article |
Influences of Spindle Speed and Feed Rate on Exit Burr Height and Workpiece Diameter in Drilling Forging Brass |
| Date of Acceptance |
19 June 2018 |
| Journal |
| Title of Journal |
Solid State Phenomena |
| Standard |
SCOPUS |
| Institute of Journal |
Trans Tech Publications, Switzerland |
| ISBN/ISSN |
1662-9779 |
| Volume |
2018 |
| Issue |
279 |
| Month |
June |
| Year of Publication |
2018 |
| Page |
67-71 |
| Abstract |
Exit burrs are formed on the end of hole and have some undesirable characters leading to
assembly quality problem. Deburring is one of the practical procedures used to solve this problem.
Nevertheless, this step is a time consuming and causes high operation cost. This work studied the
experimental investigations in drilling forging brass using a special tungsten carbide drilling tools.
The exit burr height and workpiece diameter were measured at various spindle speeds and feed rates
based on 2k plus center point experimental design and investigated by analysis of variance (ANOVA).
The results of ANOVA indicated that spindle speed and feed rate on exit burr height and workpiece
diameter were statistically significant at the level of significance of 0.05. |
| Keyword |
Burr, drilling, forging brass, spindle speed, design of experiments |
| Author |
|
| Reviewing Status |
มีผู้ประเมินอิสระ |
| Status |
ตีพิมพ์แล้ว |
| Level of Publication |
นานาชาติ |
| citation |
true |
| Part of thesis |
true |
| Attach file |
|
| Citation |
0
|
|
|
|
|
|
|
|
|
Journal Publication
ไทย